Making a kindle case from leather scraps and superglue

I wanted a cover for my kindle and had been pondering it for a while drawing up some ideas of more and more elaborate cases with various pockets. Then I decided to try and focus a bit and reduce the case to the bare basics. I like to have a notepad with me when I read as I tend to get in a thinking mood quite often when I have been reading so it’s nice to have somewhere to get those thoughts out of my head. I had a few of these little notebooks that seemed to be just a little bit bigger than the kindle and so I thought they could be used to protect the screen of the kindle as well.

So I had a basic layout idea now it was to the scraps bin to find something to make it out of. I brought a load of leather offcuts for another project and had a load left. You can buy them by the Kg on ebay and get a random selection of small bits which are all quite useful. I found one that was almost big enough and folded it into a rough shape. I say almost big enough as it did not quite fit but looked like I could botch it a little so ploughed on.  I got a rough idea of the layout then used a rotary cutter to trim off some the excess till I had a rough shape.

Next up was working out how to hold it in pace ready for stitching. CA or superglue was the chosen solution it had two key properties, it sticks leather quickly and I have some to hand. So I ran a few beads of glue on the leather around the kindle and folded over one side. Held it down for a few seconds then breathed a sigh of relief as I manged to pull out the kindle and thus proving I had not glued it in place.

Repeating this for the note and pen and then adding a couple of extra tabs at the bottom of the notebook where the scrap did not quite fit it was starting to come together nicely. I grabbed one of the cut offs from earlier and made a little strap, again gluing it in place. Then left it to set for a while and when I came back was pretty pleased and impressed by the strength of the bond. I left if like that for a few weeks and it seemed to be holding up fine. In the end I decided to run a row of stitching along some of the glue joints just to be sure; using the Hackspace’s trusty Singer 413. The strap on the front is still just glued on and seems to be holding up fine though.

When I started to build this I just wanted to get started so this quick build method of superglue and rotary cutter seems like a really easy way to get a prototype made but in fact it looks like I’m sticking with this one for a while longer. There is something to be said for just getting started with what you have at hand rather than thinking things through and not making something. I would probably change some things if I make another one but I only know that now because I have been using this one for a while. Get out there and make something today!

Leave a Reply

Your email address will not be published. Required fields are marked *